Skip to search boxSkip to navigationSkip to main content

Scrutinizing pre- and post-device fabrication properties of atomic layer deposition WS2 thin films

  • Emma Coleman(corresponding author)(Corresponding author)
    ,
  • Scott Monaghan
    ,
  • Farzan Gity
    ,
  • Gioele Mirabelli
    ,
  • Ray Duffy
    ,
  • Brendan Sheehan
*Corresponding author for this work
Output:
Contribution to journal
Article
Academic
Peer-review

Open access

Information

Output type

Output:
Contribution to journal
Article
Academic
Peer-review

Original language

English

Article number

011901

Journal (Volume, Issue Number)

Applied Physics Letters (Volume 123, Issue 1)

Publication milestones

  • Published - 03/07/2023

Publication status

Published - 03/07/2023

ISSN

0003-6951

Funding Details

This work was supported by the European Commission through project ASCENT+: Access to European Infrastructure for Nanoelectronics, funded under H2020 grant 871130, and the financial support of Science Foundation Ireland through the AMBER 2 (12/RC/2278_P2), European Research Council (Grant Agreement No. 648787-ALDof2DTMDs).

Abstract

In this work, we investigate the physical and electrical properties of WS2 thin films grown by a plasma-enhanced atomic layer deposition process, both before and after device fabrication. The WS2 films were deposited on thermally oxidized silicon substrates using the W(NMe2)2(NtBu)2 precursor and a H2S plasma at 450 °C. The WS2 films were approximately 8 nm thick, measured from high-resolution cross-sectional transmission electron imaging, and generally exhibited the desired horizontal basal-plane orientation of the WS2 layers to the SiO2 surface. Hall analysis revealed a p-type behavior with a carrier concentration of 1.31 × 1017 cm−3. Temperature-dependent electrical analysis of circular transfer length method test structures, with Ni/Au contacts, yielded the activation energy (Ea) of both the specific contact resistivity and the WS2 resistivity as 100 and 91 meV, respectively. The similarity of these two values indicates that the characteristics of both are dominated by the temperature dependence of the WS2 hole concentration. Change in the material, such as in sheet resistance, due to device fabrication is attributed to the chemicals and thermal treatments associated with resist spinning and baking, ambient and UV exposure, metal deposition, and metal lift off for contact pad formation.

Bibliographical Note

Funding Information: This work was supported by the European Commission through project ASCENT+: Access to European Infrastructure for Nanoelectronics, funded under H2020 grant 871130, and the financial support of Science Foundation Ireland through the AMBER 2 (12/RC/2278_P2), European Research Council (Grant Agreement No. 648787-ALDof2DTMDs).

Metrics

Metrics

SciVal
FWCI
0.42
SciVal
Author count
9
SciVal
Paper percentile
47
SciVal
citations
4
Scopus
citations
4
Download statistics
Download count
206

PlumX, opens in new tab

Captures
8
Mentions
1
Citation count
5