Skip to search boxSkip to navigationSkip to main content

Light management in luminescent solar concentrators : aligned organic dyes and organic wavelength selective reflectors

Output:
Thesis
Phd Thesis 1 (Research TU/e / Graduation TU/e)
Academic

Open access

Information

Output type

Output:
Thesis
Phd Thesis 1 (Research TU/e / Graduation TU/e)
Academic

Original language

English

Qualification

Doctor of Philosophy

Publication milestones

  • Published - 2012

Publication status

Published - 2012

Supervisors/Advisors

Place of publication

Eindhoven

Award date

01/11/2012

Publisher

Technische Universiteit Eindhoven
978-94-6191-451-4

Abstract

Dwindling oil reserves have turned world governments towards the use of renewable energy sources. In particular, buildings, which account for 40% of all energy usage in well-developed countries, have attracted special attention for the possibility of implementing energy generating devices from renewable energy sources. For buildings, the devices must be adaptable to the demands of the architect and should not detract from the appearance of the structure, while maintaining a low costs for the generated energy (~€0.06/kWh). An energy source readily available for each building is the sun. The implementation of standard photovoltaic cells in these constructions has been difficult, since the cost of the energy generated is still too high and the adaptability to the demands of the architect is limited. An alternative to standard photovoltaic cells is a luminescent solar concentrator (LSC) which holds promise for low cost and of better meeting the demands of the architects. LSCs are simple devices that consist of an optically transparent plastic or glass plate acting as waveguide. A luminophore is embedded in or as a thin film on top of the waveguide and absorbs the incoming sunlight, re-emitting this light as photons with a longer wavelength. Part of this emitted light is waveguided in the plate due to total internal reflection and transported to the edges of the plate where small photovoltaic cells are placed which convert the photons into electricity. The efficiency of LSCs has been limited due to several loss mechanisms. One of the most important losses is the photons lost through the surfaces of the plate, a result of a limited trapping efficiency of emitted photons combined with sequential re-absorption and re-emission of photons in the waveguide mode (called ‘photon recycling’). In this work, I present a simple model that predicts the spatial distribution of emitted photons from dichroic dye ensembles in an isotropic or liquid crystalline host. The model predicts the emission from dichroic dyes in an isotropic host is non-isotropic when illuminated with a collimated light source. The model furthermore predicts that by changing the alignment of the dichroic dye molecules, the spatial distribution of the emitted photons may be altered. The model is tested by experiments in which the molecular order of dichroic dyes in a planar aligned liquid crystal is changed. LSC waveguide with the dye molecules aligned parallel to the top and bottom surfaces and parallel to two edges (planar) were made, and I measure the light energy emitted from the edge parallel to the alignment direction can be 60% higher than from the edge perpendicular to the alignment direction, supporting the calculated result. The amount of surface loss from LSCs with dichroic fluorescent dye molecules randomly distributed in the LSC is calculated and determined experimentally. Calculations show that the trapping efficiency is 74.3%, meaning 25.7% of the photons are lost through the surfaces of the LSC waveguide. Experiments show that the photons lost though the surface of LSCs made from polycarbonate is actually ~ 50% of all emitted photons for LSCs containing BASF Lumogen F Red 305, the standard dye used in LSCs. This large surface loss is caused by photon recycling events of waveguided photons and the consequent change in propagation path. Aligning dichroic dye molecules can be used to reduce surface loss of LSCs. Calculations and experiments both show aligning dye molecules in a homeotropic fashion result in a reduction of surface loss to less than 10%, but with concurrent reduction in the incident light absorbed. Tilting the director of the dye ensembles at an intermediate angle can combine the advantages of planar (increased absorption) and homeotropic (decreased surface loss) dye ensembles. Prediction of the optimal tilt angle and order of the dye ensemble with the model presented in this thesis was not possible. I suggest this model needs implementation in simulation software so the influence of photon recycling is better represented. A second method to reduce the surface loss in LSCs is the application of organic wavelength selective reflectors transmitting the incoming sunlight and reflecting the light emitted by the luminophore. Calculations show approximately 90% of all surface emitted photons from luminophore BASF Lumogen Red 305 may be reflected back into the LSC waveguide, leading to an increase in LSC efficiency of 66% if a 400 nm bandwidth reflector is used, or by 45% with a 175 nm reflector. Experimentally, the increase in energy leaving the edge of an LSC containing Red 305 with a peak absorbance of 1.0 is only about 5%. Reducing the number of photon recycling events in an experimental system with a 175 nm bandwidth reflector led to enhancement in LSC efficiency of around 20%, showing it is photon recycling that limits the effectiveness of the wavelength selective reflectors. The organic wavelength selective reflectors show angular dependency: the reflection band shifts to shorter wavelengths with increasing angle of incidence, possibly leading to the reflection of absorbable incident sunlight at these larger angles. Calculations show that for non-direct sunlight or direct sunlight at oblique incidence angles there is a decrease in effectiveness of the reflectors and potential decrease in device efficiency. Simulations show that special dispersion cholesteric reflectors (SDC) have a less pronounced angular dependency. Using SDC reflectors will enhance the LSC efficiency in any solar condition and only incident light at angles larger than 70° are reflected away by the reflector. Both luminophore alignment and organic selective reflectors presented in this thesis reduce the surface loss of the LSC, and increase the device efficiency. Experimentally, the increase is not as large as expected from the calculations. To increase the LSC efficiency the methods presented in this thesis need to be employed using a luminophore with a larger Stokes shift, so photon recycling is limited. In addition, the amount of sunlight that can be absorbed by the luminophore molecules (e.g. the spectral coverage) needs to be increased for the LSC to become viable in the marketplace, as this is still the single largest loss in LSCs.

Documents and Links

Metrics

Metrics

Download statistics
Download count
2028

UN SDGs

In 2015, UN member states agreed to 17 global Sustainable Development Goals (SDGs) to end poverty, protect the planet and ensure prosperity for all. This output contributes to the following SDG(s):
  • SDG 7 - Affordable and Clean Energy
    SDG 7 Affordable and Clean Energy