Skip to search boxSkip to navigationSkip to main content

Improving the performance of amorphous and crystalline silicon heterojunction solar cells by monitoring surface passivation

  • J.W.A. Schüttauf
    ,
  • C.H.M. Van Der Werf
    ,
  • I.M. Kielen
    ,
  • W.G.J.H.M. van Sark
    ,
  • J.K. Rath
    ,
  • R.E.I. Schropp
Output:
Contribution to journal
Article
Academic
Peer-review

Information

Output type

Output:
Contribution to journal
Article
Academic
Peer-review

Original language

English

Pages from-to (Number of pages)

Pages 2245-2248 (4 pages)

Journal (Volume, Issue Number)

Journal of Non-Crystalline Solids (Volume 358, Issue 17)

Publication milestones

  • Published - 01/09/2012

Publication status

Published - 01/09/2012

ISSN

0022-3093

Abstract

The influence of thermal annealing on the crystalline silicon surface passivating properties of selected amorphous silicon containing layer stacks (including intrinsic and doped films), as well as the correlation with silicon heterojunction solar cell performance has been investigated. All samples have been isochronally annealed for 1 h in an N 2 ambient at temperatures between 150 °C and 300 °C in incremental steps of 15 °C. For intrinsic films and intrinsic/n-type stacks, an improvement in passivation quality is observed up to 255 °C and 270 °C, respectively, and a deterioration at higher temperatures. For intrinsic/n-type a-Si:H layer stacks, a maximum minority carrier lifetime of 13.3 ms at an injection level of 10 15 cm - 3 has been measured. In contrast, for intrinsic/p-type a-Si:H layer stacks, a deterioration in passivation is observed upon annealing over the whole temperature range. Comparing the lifetime values and trends for the different layer stacks to the performance of the corresponding cells, it is inferred that the intrinsic/p-layer stack is limiting device performance. Furthermore, thermal annealing of p-type layers should be avoided entirely. We therefore propose an adapted processing sequence, leading to a substantial improvement in efficiency to 16.7%, well above the efficiency of 15.8% obtained with the 'standard' processing sequence.

Metrics

Metrics

SciVal
FWCI
5.02
SciVal
Author count
6
SciVal
Paper percentile
96
SciVal
citations
31
SciVal
Top percentile
5
Download statistics
Download count
3
Scopus
citations
31

PlumX, opens in new tab

Captures
34
Citation count
32