Skip to search boxSkip to navigationSkip to main content

From on-line to in-line quality control of the bulk yield stress for digitally fabricated concrete

*Corresponding author for this work
Output:
Contribution to journal
Article
Academic
Peer-review

Open access

Information

Output type

Output:
Contribution to journal
Article
Academic
Peer-review

Original language

English

Article number

108382

Journal (Volume, Issue Number)

Cement and Concrete Research (Volume 210)

Publication milestones

  • E-pub ahead of print - 06/09/2026
  • Published - 12/2026

Publication status

E-pub ahead of print - 06/09/2026

ISSN

0008-8846

Abstract

High-resolution quality control is essential to produce reliable concrete products that are optimized towards material minimization. For this purpose, in-line measurements have a high potential since they measure the material that is later used in the product at a high frequency. The current paper assesses how well various in-line measurements correlate with the bulk yield strength at deposition. Accordingly, a novel methodology is presented that allows for the correction of the contribution of variation in flow rate to the in-line readings, thereby improving the predictions. An experimental program is performed on a 3D concrete printing system with various in-line sensors. The power of the pumping motor is found to have the weakest correlation with the yield stress at deposition, with an adjusted R-squared of 0.28, explained by the low efficiency of the pump, which causes noise in the measurement. The pressure difference over a straight cylindrical and the torsional force that is required to provide an oscillatory moment to this straight steel pipe are found to have a moderate correlation with an adjusted R-squared of 0.53 and 0.46, respectively, which is explained since yielding of the bulk concrete did not occur. Lastly, the pressure difference over the nozzle is found to have a good correlation with the bulk yield strength at deposition, with an adjusted R-squared value of 0.76, which is explained since yielding of the bulk concrete occurred. It is thus recommended to measure the pressure difference over the nozzle for in-line quality control of the bulk yield stress.

Bibliographical Note

Publisher Copyright: © 2026 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license. http://creativecommons.org/licenses/by/4.0/

Metrics

Metrics

SciVal
Author count
3
SciVal
Paper percentile
72
Download statistics
Download count
20