Skip to search boxSkip to navigationSkip to main content

Diamond-like-carbon LC-alignment layers for application in LCOS microdisplays

  • Ageeth Bol(corresponding author)
    ,
  • Joseph Dvorak
    ,
  • Dario Arena
*Corresponding author for this work
  • Philips
    ,
  • Montana State University
    ,
  • Brookhaven National Laboratory
Output:
Contribution to journal
Article
Academic
Peer-review

Information

Output type

Output:
Contribution to journal
Article
Academic
Peer-review

Original language

English

Pages from-to (Number of pages)

Pages 281-287 (7 pages)

Journal (Volume, Issue Number)

Journal of the Society for Information Display (Volume 13, Issue 4)

Publication milestones

  • Published - 01/04/2005

Publication status

Published - 01/04/2005

ISSN

1071-0922

Abstract

To improve the lifetime and yield of LCOS microdisplays, non-contact LC alignment techniques using inorganic materials are under investigation. This report focuses on oblique ion-beam treatment of diamond-like carbon (DLC) layers, and in particular on the influence of the ion dose on the LC alignment on DLC, keeping the ion-beam angle (40°) and ion-beam energy (170 eV) the same. LC alignment on ion-milled DLC layers is uniform if the ion dose is between 3.8 × 10-4 C/cm2 and 5.5×10 -3 C/cm2. Above and below this ion dose range, non-uniform alignment is observed. NEXAFS experiments show that this is caused by lack of molecular anisotropy on the surface of the ion-milled DLC layers. By varying the ion dose between 3.8 × 10-4 C/cm2 and 5.5 × 10-3 C/cm2, LC molecules have an average pre-tilt between 3° and 5°, which is within the desired range for application in LCOS microdisplays. The lifetime of the LCOS microdisplays with ion-milled DLC for projection-TV application is, however, shorter than the lifetime of microdisplays with Pl layers. Ion milling probably creates a reactive surface that is unstable under the high light fluxes used in projection TVs. A solution for this problem could be chemical passivation of the ion-milled alignment layers. Initial experiments with passivation of ion-milled Pl resulted in an increase in lifetime, but the lifetime after passivation was still lower than the lifetime of rubbed Pl layers (factor 0.7). Nevertheless, ion-milling of DLC or Pl can be a good alternative LC alignment technique in other LCD applications. LC-alignment layers based on inorganic layers such as obliquely deposited SiO2 films would be a better option for application in LCOS microdisplays due to their higher light stability.

Metrics

Metrics

SciVal
citations
5
Scopus
citations
5
SciVal
FWCI
1.11
SciVal
Author count
3
SciVal
Paper percentile
74

PlumX, opens in new tab

Citation count
5
Captures
3