The melting performance of single screw extruders. II

J.F. Ingen Housz, H.E.H. Meijer

Onderzoeksoutput: Bijdrage aan tijdschriftTijdschriftartikelAcademicpeer review

9 Citaten (Scopus)
101 Downloads (Pure)

Samenvatting

In the previous paper (1) the melting performance of a number of recent screw designs was analyzed, using a rather simple theory. A new screw design was proposed. Here the results of more elaborate calculations are given in which the influence of the flight clearance and of a shear-thinning temperature dependent viscosity are investigated. The former conclusions are not altered in essence by these effects. Experimental results with a prototype screw are presented, showing that melting capacity is increased. Up to 100 percent increase in throughput is possible in the high RPM range (in comparison with a much longer traditional compression screw), provided that the feed capacity is sufficient. This usually requires the use of a grooved, well-cooled, feed section; the capacity of such a feed section depends, for a given screw geometry, on channel depth and granule dimensions. The melt leaves the melting section at a relatively low temperature. The melting section only melts the material and does not raise its temperature unnecessarily. A further step towards separating distinct tasks of the extruder by functional screw design has been made.
Originele taal-2Engels
Pagina's (van-tot)1156-1161
TijdschriftPolymer Engineering and Science
Volume21
Nummer van het tijdschrift17
DOI's
StatusGepubliceerd - 1981

Vingerafdruk Duik in de onderzoeksthema's van 'The melting performance of single screw extruders. II'. Samen vormen ze een unieke vingerafdruk.

  • Citeer dit