Experimental validation of the performance of a microreactor for the high-throughput screening of catalytic coatings

M.J.M. Mies, E.V. Rebrov, L. Deutz, C.R. Kleijn, M.H.J.M. Croon, de, J.C. Schouten

Onderzoeksoutput: Bijdrage aan tijdschriftTijdschriftartikelAcademicpeer review

22 Citaten (Scopus)

Samenvatting

In this paper, the results of computational fluid dynamics simulations of flow, temperature, and concentration distributions used in the design of a microreactor for the high-throughput screening of catalytic coatings (Mies et al., Chem. Eng. J. 2004, 101, 225) are compared with experimental data, and good agreement is obtained in all cases. The experimental results on flow distribution were obtained from laser Doppler anemometry measurements in the range of Reynolds numbers from 6 to 113. The measured flow nonuniformity in the separate reactor compartments was below 2%. The temperature distribution was obtained from thermocouple measurements. The temperature nonuniformity between the reactor compartments was below 3 K at a maximum heat production rate of 1.3 W in ethylene oxidation at 425 C over CuO/Al2O3/Al coatings. With respect to concentration gradients, a deviation from the average rate of reaction of only 2.3% was obtained at realistic process conditions in the ethylene ammoxidation process over identical Co-ZSM-5 coatings in all reactor compartments. The cross talking noise between separate compartments does not exceed 0.1% when the reactor parts have a smooth surface finish. This illustrates the importance of ultraprecision machining of surfaces in microtechnology, when interfaces cannot be avoided.
Originele taal-2Engels
Pagina's (van-tot)3922-3931
TijdschriftIndustrial and Engineering Chemistry Research
Volume46
Nummer van het tijdschrift12
DOI's
StatusGepubliceerd - 2007

Vingerafdruk

Duik in de onderzoeksthema's van 'Experimental validation of the performance of a microreactor for the high-throughput screening of catalytic coatings'. Samen vormen ze een unieke vingerafdruk.

Citeer dit