A 0.8mW 5bit 250MS/s time-interleaved asynchronous digital slope ADC

P.J.A. Harpe, C. Zhou, K.J.P. Philips, H.W.H. Groot, de

Onderzoeksoutput: Bijdrage aan tijdschriftTijdschriftartikelAcademicpeer review

17 Citaten (Scopus)
5 Downloads (Pure)


Slope and digital-ramp converters are normally limited to very low sampling rates, since they require a digital counter at a highly oversampled clock rate. In this work, an asynchronous digital slope architecture is introduced that only requires a nonoversampled clock, thus enabling a much higher speed of operation. At the same time, the low complexity and the inherent accuracy of the slope-architecture enable very good power-efficiency without using complex calibration techniques. A two-channel time-interleaved 5-bit asynchronous digital slope ADC was implemented in a 90-nm CMOS technology and occupies 160 µm × 200 µm. The measured prototype achieves an ENOB of 4.6 bit, while operating at 250 MS/s and consuming 0.8 mW from a 1-V supply.
Originele taal-2Engels
Pagina's (van-tot)2450-2457
Aantal pagina's8
TijdschriftIEEE Journal of Solid-State Circuits
Nummer van het tijdschrift11
StatusGepubliceerd - 2011


Duik in de onderzoeksthema's van 'A 0.8mW 5bit 250MS/s time-interleaved asynchronous digital slope ADC'. Samen vormen ze een unieke vingerafdruk.

Citeer dit