Tough magnesium phosphate-based 3D-printed implants induce bone regeneration in an equine defect model

Nasim Golafshan, Elke Vorndran, Stefan Zaharievski, Harold Brommer, Firoz Babu Kadumudi, Alireza Dolatshahi-Pirouz, Uwe Gbureck, René van Weeren, Miguel Castilho (Corresponding author), Jos Malda

Research output: Contribution to journalArticleAcademicpeer-review

Abstract

One of the important challenges in bone tissue engineering is the development of biodegradable bone substitutes with appropriate mechanical and biological properties for the treatment of larger defects and those with complex shapes. Recently, magnesium phosphate (MgP) doped with biologically active ions like strontium (Sr2+) have shown to significantly enhance bone formation when compared with the standard calcium phosphate-based ceramics. However, such materials can hardly be shaped into large and complex geometries and more importantly lack the adequate mechanical properties for the treatment of load-bearing bone defects. In this study, we have fabricated bone implants through extrusion assisted three-dimensional (3D) printing of MgP ceramics modified with Sr2+ ions (MgPSr) and a medical-grade polycaprolactone (PCL) polymer phase. MgPSr with 30 wt% PCL (MgPSr-PCL30) allowed the printability of relevant size structures (>780 mm3) at room temperature with an interconnected macroporosity of approximately 40%. The printing resulted in implants with a compressive strength of 4.3 MPa, which were able to support up to 50 cycles of loading without plastic deformation. Notably, MgPSr-PCL30 scaffolds were able to promote in vitro bone formation in medium without the supplementation with osteo-inducing components. In addition, long-term in vivo performance of the 3D printed scaffolds was investigated in an equine tuber coxae model over 6 months. The micro-CT and histological analysis showed that implantation of MgPSr-PCL30 induced bone regeneration, while no bone formation was observed in the empty defects. Overall, the novel polymer-modified MgP ceramic material and extrusion-based 3D printing process presented here greatly improved the shape ability and load-bearing properties of MgP-based ceramics with simultaneous induction of new bone formation.

Original languageEnglish
Article number120302
Number of pages11
JournalBiomaterials
Volume261
DOIs
Publication statusPublished - Dec 2020

Keywords

  • 3D printing
  • Bone tissue engineering
  • Composites
  • In vivo
  • Magnesium phosphates
  • Osteoinduction
  • Strontium

Fingerprint Dive into the research topics of 'Tough magnesium phosphate-based 3D-printed implants induce bone regeneration in an equine defect model'. Together they form a unique fingerprint.

Cite this