Orienting melt to produce on lab-microscale high performance and ultra thin foils

Efficient molecular orientation of polymers in the melt-or solution state requires concentric contraction flows, which result in single or multi-filament fiber shaped products. Directed molecular orientation in pipes, sheets, foils and films, like strip bi-axially, planar or tri-axial, are difficult to achieve and require complex multi-stage processing often supported by the addition of extra external magnetic, electric, or temperature gradient fields that put constraints to the materials to be processed. Here we aim at a simple continuous process to produce uni-axially oriented foils, by designing a special die in a standard miniaturized laboratory scale film casting process. The internal of the die consist of a fiber forming, and a fiber fusing part. The specific design of the fiber forming part allows the combination of the fibers formed, without them crossing, into a line that forms a sheet. Flow in the total volume around the slit ends up in molecularly oriented flow inside the slit. To preserve orientation, an air gap extrusion process follows the exiting slit flow, to allow for a strong draw down under high melt stress. Small air-gaps and a cold cooling nose, combined with a supporting carrying film, make the total process easy, clean and cheap, and the products unique. We will demonstrate that, mounted on the miniature Xplore MC 15 lab compounder, the device is able to produce not only high performance fully oriented foils based on a thermotropic liquid crystalline polyester (Vectra), but also extremely thin foils of polyamides and polyesters. In the last application, the melt orientation is used only to temporary obtain a high melt strength that allows a high draw-ability in the air gap.